ZOLL M Series CCT Defibrillator Rev A User Manual
Configuration guide
Advertising
Table of contents
Document Outline
- CONFIGURATION GUIDE
- Introduction
- Configuring the Unit
- Configuration Settings
- Notch Filter
- Allow Card Erase
- Display Elapsed Time
- Voice Markers Enabled
- Set Report Restart Delays
- Print 12 Lead 4x3
- Auto Self-Test Timeout Period
- Async Softkey in Pace Mode
- Code Markers
- Device Identifier
- Manual Mode Passcode (Advanced AED Models)
- Configuration Mode Passcode
- Energy Level: Shock 1, 2, 3
- Auto Analyze 3 Times
- "NO SHOCK ADVISED" Prompt
- "CHECK PATIENT" Prompt
- Display DO CPR Message
- Display ECG in Semi-Auto Mode
- Store to Card in Auto Monitor Mode (AED models)
- Auto Charge in Advisory Mode
- Record to Card in Advisory Mode
- Enable Voice In Advisory Mode
- Display Heart Rate in Semi-Auto Mode
- Display Lead on Power-Up
- Frequency Response
- Enable 12-Lead in Semi-Auto Mode (AED with 12-Lead)
- QRS Volume on Power-Up
- Pace Rate Setting on Power-Up
- Display Implanted Pace Spikes
- Gain On Power-Up
- Retain SYNC after Defib
- Auto Generate Strips
- Print 3 Leads When Leads Sel
- Report Memory Card Errors
- Auto Analyze on Power Up (AED Semi-Automatic Mode)
- Auto Transmit After 12 Lead
- Fax/Communication Phone Numbers
- 12 Lead Analysis
- 12 Lead Printout
- Print 12 Lead Measurements
- 12 Lead Fax Format
- Print 2 Copies 12 Lead
- Set Lead Groups
- 12 Lead Freq Response
- Lead Group Default
- Print 12 Lead Interpretation
- Defib Default to Pads
- Cell Phone Type
- EtCO2 Options
- Enable Leads Off
- Blood Pressure Units
- NIBP Auto Interval Default
- Trigger NIBP Meas on BP Alarm
- Trigger NIBP Meas on HR Alarm
- NIBP First Inflate Pressure Default
- Basic Auto Energy Escalation
- MUSE Site and Location
- 12 Lead Secs Per Lead
- 12 Lead Print Speed
- Upload Baud Rate
- Trending Report Zoom Level
- Trending Enabled
- AED Defib Ready Hold Time (AED Semi-Automatic Mode)
- Battery Type Used
- Alarm Limits at Power Up
- Alarms Active at Power Up
- Low Battery Tone
- Clock Synchronization
- Daylight Savings
- Card Capacity Message Enabled
- Erase Card Prompt at Pwr Off
- Remove Card Prompt at Pwr Off
- Sync Defib Excluded
- PTCA Settings
- Power Up Patient Type (NIBP)
- Temperature Units
- Display Colors
- Power Up Trace Selection
- IBP1 Label at Power Up
- IBP2 Label at Power Up
- IBP1 Range at Power Up
- IBP2 Range at Power Up
- Configuration Option Tables