IEI Integration IOWA-LX-600 - Manual (Page 30)

IOWA-LX-600 Half-size CPU Card
Page 16
USB connector 8-pin header CN13
VCC ISA power connector 3-pin header CN1
Table 3-1: Peripheral Interface Connectors
3.1.3 External Interface Panel Connectors
The table below lists the connectors on the external I/O panel.
Connector Type Label
Ethernet connector RJ-45 CN22
Keyboard and mouse connector PS/2 CN24
Serial port DB-9 male CN21
VGA connector DB-15 female CN23
Table 3-2: Rear Panel Connectors
3.2 Internal Peripheral Connectors
The section describes all of the connectors on the IOWA-LX-600.
3.2.1 ATX Power Enable Connector
CN Label: CN3
CN Type: 3-pin wafer (1x3)
CN Location: See
5
Figure 3-2
CN Pinouts: See
5
Table 3-3
The ATX power supply enable connector enables the IOWA-LX-600 to be connected to an
ATX power supply. In default mode, the IOWA-LX-600 can only use an AT power supply.
To enable an ATX power supply the AT Power Select jumper must also be configured.