IEI Integration IOWA-LX-600 - Manual (Page 69)

IOWA-LX-600 Half-size CPU Card
Page 55
4.8.3 USB Cable
The IOWA-LX-600 is shipped with a dual port USB 2.0 cable. To connect the USB cable
connector, please follow the steps below.
Step 1: Locate the connectors. The locations of the USB connectors are shown in
Chapter 3.
WARNING:
If the USB pins are not properly aligned, the USB device can burn out.
Step 2: Align the connectors. The cable has two connectors. Correctly align pin 1on
each cable connector with pin 1 on the IOWA-LX-600 USB connector.
Step 3: Insert the cable connectors . Once the cable connectors are properly aligned
with the USB connectors on the IOWA-LX-600, connect the cable connectors to
the on-board connectors. See
6
Figure 4-11.
Figure 4-11: Dual USB Cable Connection