IEI Integration PICOe-GM45A - Manual (Page 100)

PICOe-GM45A Half-Size CPU Card
Page 100
Figure 5-13: SATA Power Drive Connection
5.7.4 USB Cable (Dual Port) with Slot Bracket
The PICOe-GM45A is shipped with a dual port USB 2.0 cable. To connect the USB cable
connector, please follow the steps below.
Step 1: Locate the connectors. The locations of the USB connectors are shown in
Chapter 3.
WARNING:
If the USB pins are not properly aligned, the USB device can burn out.
Step 2: Align the connectors. The cable has two connectors. Correctly align pin 1on
each cable connector with pin 1 on the PICOe-GM45A USB connector.
Step 3: Insert the cable connectors . Once the cable connectors are properly aligned
with the USB connectors on the PICOe-GM45A, connect the cable connectors
to the on-board connectors. See
814H
Figure 5-14.