IEI Integration IEM-LX v1.10 - Manual (Page 34)

IEM-LX-800 ETX CPU Module
Page 18
10Mbps and 100Mbps operation
Supports 10Mbps and 100Mbps N-way auto-negotiation
Supports 25MHz Crystal or 25MHz OSC as the internal clock source
Complies with PC99/PC2001 standards
Supports ACPI power management
Provides PCI bus master data transfer
Provides PCI memory space or I/O space mapped data transfer
Supports PCI clock speed of 16.75MHz-40MHz
Advanced power saving mode
Supports Wake-on-LAN and remote wake-up (AMD Magic Packet™, Link
Change, and Microsoft® Wake-up frame)
Half/Full duplex capability
Supports Full Duplex Flow Control (IEEE 802.3x)
Provides interface to 93C46 EEPROM to store resource configuration and ID
parameters
Provides PCI clock run pin
Provides LED pins for network operation status indication
2.5/3.3V power supply with 5V tolerant I/Os
2.6.3 PCI to ISA Bridge
An ITE IT8888G PCI to ISA bridge single function device connects the on-board
IEM-LX-800 ISA bus ETX-X2 connector to the GeodeLink™ PCI bridge. The IT8888G has
a PCI specification v2.1 compliant 32-bit PCI bus interface and supports both PCI Bus
master and slave. The PCI interface supports both programmable positive and full
subtractive decoding schemes. Some of the features of the IT8888G PCI to ISA bridge are
listed below.
PCI Interface
Programmable PCI Address Decoders
PC/PCI DMA Controller
Distributed DMA Controller
ISA Interface
SM Bus
1 analog line-level mono output: MONO_OUT