IEI Integration IEM-LX v1.10 - Manual (Page 38)

IEM-LX-800 ETX CPU Module
Page 22
3.1 Anti-static Precautions
WARNING:
Failure to take ESD precautions during the installation of the
IEM-LX-800 may result in permanent damage to the IEM-LX-800 and
severe injury to the user.
Electrostatic discharge (ESD) can cause serious damage to electronic components,
including the IEM-LX-800. Dry climates are especially susceptible to ESD. It is therefore
critical that whenever the IEM-LX-800, or any other electrical component is handled, the
following anti-static precautions are strictly adhered to.
Wear an anti-static wristband: Wearing a simple anti-static wristband can
help to prevent ESD from damaging the board.
Self-grounding: Before handling the board touch any grounded conducting
material. During the time the board is handled, frequently touch any
conducting materials that are connected to the ground.
Use an anti-static pad: When configuring the IEM-LX-800, place it on an
antic-static pad. This reduces the possibility of ESD damaging the
IEM-LX-800.
Only handle the edges of the PCB: When handling the PCB, hold the PCB
by the edges.
3.2 Unpacking
3.2.1 Unpacking Precautions
When the IEM-LX-800 is unpacked, please do the following:
Follow the anti-static precautions outlined in Section 3.1.
Make sure the packing box is facing upwards so the IEM-LX-800 does not fall
out of the box.
Make sure all the components shown in Section 3.3 are present.