IEI Integration IEM-LX v1.10 - Manual (Page 92)

IEM-LX-800 ETX CPU Module
Page 76
Reset Configuration Data [Disabled]
Use the Reset Configuration Data option to reset the Extended System Configuration
Data (ESCD) when exiting setup if booting problems occur after a new add-on is installed.
Disabled (Default) ESCD will not be reconfigured
Enabled ESCD will be reconfigured after you exit setup
Resources Controlled By [Auto (ESCD)]
Use the Resources Controlled By option to either manually configure all the boot and
plug and play devices, or allow BIOS to configure these devices automatically. If BIOS is
allowed to configure the devices automatically IRQs, DMA and memory base address
fields cannot be set manually because BIOS automatically assigns them.
Auto(ESCD) (Default) BIOS automatically configures plug and play devices as
well as boot devices.
Manual Manually configure the plug and play devices and any
other boot devices.
x IRQ Resources [Press Enter]
If Manual is selected in the Resources Controlled By option then a user can configure
the IRQ Resources. To do this, select IRQ Resources and press E NTER . A new menu
appears. (See BIOS Menu 10)