IEI Integration IMBA-G412ISA v1.00 User Manual
Page 61
4810/26/2010158
Page 48
IMBA-G412ISA ATX Motherboard
Step 3:
Mount the cooling kit. Gently place the cooling kit on top of the CPU. Make
sure the four threaded screws on the corners of the cooling kit properly pass
through the predrilled holes on the bottom of the PCB.
Step 4:
Secure the cooling kit. From the solder side of the PCB, align the support
bracket to the screw threads on heat sink that were inserted through the PCB
holes. (See
651H651H651H
Figure 4-6)
Figure 4-6: Securing the Heat sink to the IMBA-G412ISA
Step 5:
Tighten the screws. Use a screwdriver to tighten the four screws. Tighten each
nut a few turns at a time and do not over-tighten the screws.
Step 6:
Connect the fan cable. Connect the cooling kit fan cable to the fan connector
on the IMBA-G412ISA. Carefully route the cable and avoid heat generating
chips and fan blades.
Step 0: