IEI Integration IMBA-G412ISA v1.00 - Manual (Page 75)

6210/26/2010158
Page 62
IMBA-G412ISA ATX Motherboard
Figure 4-20: Parallel Device Connector
Step 3: Secure the connector. Secure the DB-25 connector to the external interface by
tightening the two retention screws on either side of the connector.
4.6.5 Serial Device Connection
The IMBA-G412ISA has one male DB-9 connectors on the external peripheral interface
panel for a serial device. Follow the steps below to connect a serial device to the
IMBA-G412ISA.
Step 1: Locate the DB-9 connector. The location of the DB-9 connector is shown in
Chapter 3.
Step 2: Insert the serial connector. Insert the DB-9 connector of a serial device into
the DB-9 connector on the external peripheral interface. See
677H677H677H
Figure 4-21.