IEI Integration NANO-9452 v4.02 - Manual (Page 138)

NANO-9452 EPIC Motherboard
Page 120
 19200 8,n,1
 09600 8,n,1
NOTE:
Identical baud rate setting musts be set on the host (a management
computer running a terminal software) and the slave
 Flow Control [None]
Use the Flow Control option to report the flow control method for the console redirection
application.

None D EFAULT No control flow,

Hardware Hardware is set as the console redirection

Software Software is set as the console redirection
 Redirection After BIOS POST [Always]
Use the Redirection After BIOS POST option to specify when console redirection should
occur.

Disabled The console is not redirected after POST

Boot Loader Redirection is active during POST and during Boot
Loader

Always D EFAULT Redirection is always active (Some OSes may not
work if set to Always)
 Terminal Type [ANSI]
Use the Terminal Type BIOS option to specify the remote terminal type.

ANSI D EFAULT The target terminal type is ANSI

VT100 The target terminal type is VT100