IEI Integration NANO-9452 v4.02 - Manual (Page 88)

NANO-9452 EPIC Motherboard
Page 70
Step 4: Tighten the screws. Use a screwdriver to tighten the four screws. Tighten each
nut a few turns at a time and do not over-tighten the screws.
Step 5: Connect the fan cable. Connect the cooling kit fan cable to the fan connector
on the motherboard. Carefully route the cable and avoid heat generating chips
and fan blades. See Figure 5-5. Step 0:
Figure 5-5: Connect the cooling fan cable
5.3.3 SODIMM Installation
WARNING:
Using incorrectly specified SODIMM may cause permanently damage
the NANO-9452. Please make sure the purchased SODIMM complies
with the memory specifications of the NANO-9452. SODIMM
specifications compliant with the NANO-9452 are listed in Chapter 2.
To install a SODIMM into a SODIMM socket, please follow the steps below and refer
Figure 5-6.