IEI Integration NANO-QM871 - Manual (Page 71)

NANO-QM871 EPIC SBC
Page 56
If the “CMOS Settings Wrong” message is displayed during the boot up process, the fault
may be corrected by pressing the F1 to enter the CMOS Setup menu. Do one of the
following:
Enter the correct CMOS setting
Load Optimal Defaults
Load Failsafe Defaults.
After having done one of the above, save the changes and exit the CMOS Setup menu.
Figure 4-7: Clear CMOS Jumper Location
4.6.3 LVDS Voltage Selection
Jumper Label: JP1
Jumper Type: 3-pin header
Jumper Settings: See Table 4-2
Jumper Location: See Figure 4-8
Selects the voltage of the LVDS connector.
Pin Description
Short 1-2 +3.3 V (Default)
Short 2-3 +5 V
Table 4-2: LVDS Voltage Selection Jumper Settings