9 external peripheral interface connection, 1 hdmi display device connection, Xternal – IEI Integration NANO-QM871 User Manual
Page 81: Eripheral, Nterface, Onnection, Figure 4-16: single rs-232 cable installation
NANO-QM871 EPIC SBC
Page 66
Figure 4-16: Single RS-232 Cable Installation
Step 3:
Secure the bracket. The single RS-232 connector has two retention screws
that must be secured to a chassis or bracket.
Step 4:
Connect the serial device. Once the single RS-232 connector is connected to
a chassis or bracket, a serial communications device can be connected to the
system.
4.9 External Peripheral Interface Connection
Devices can be connected to the external connectors. To install external devices, follow
the directions in the subsections below.
4.9.1 HDMI Display Device Connection
The HDMI connector transmits a digital signal to compatible HDMI display devices such
as a TV or computer screen. To connect the HDMI cable to the NANO-QM871, follow the
steps below.
Step 1:
Locate the HDMI connectors. The locations are shown in Chapter 3.
Step 2:
Align the connector. Align the HDMI connector with the HDMI port. Make sure
the orientation of the connector is correct.