IEI Integration NANO-QM871 - Manual (Page 76)

NANO-QM871 EPIC SBC
Page 61
Figure 4-11: Connect Power Cable to Power Supply
4.8.2 Audio Kit Installation
The Audio Kit that came with the NANO-QM871 connects to the 10-pin audio connector
on the NANO-QM871. The audio kit consists of three audio jacks. One audio jack, Mic In,
connects to a microphone. The remaining two audio jacks, Line-In and Line-Out, connect
to two speakers. To install the audio kit, please refer to the steps below:
Step 1: Locate the audio connector. The location of the 10-pin audio connector is
shown in Chapter 3.
Step 2: Align pin 1. Align pin 1 on the on-board connector with pin 1 on the audio kit
connector. Pin 1 on the audio kit connector is indicated with a white dot. See
Figure 4-12.