IEI Integration NANO-QM871 - Manual (Page 80)

NANO-QM871 EPIC SBC
Page 65
Figure 4-15: SATA Drive Cable Connection
Step 3: Connect the cable to the SATA disk. Connect the connector on the other end
of the cable to the connector at the back of the SATA drive. See Figure 4-15.
Step 4: To remove the SATA cable from the SATA connector, press the clip on the
connector at the end of the cable.
4.8.5 Single RS-232 Cable
The single RS-232 cable consists of one serial port connector attached to a serial
communications cable that is then attached to a D-sub 9 male connector. To install the
single RS-232 cable, please follow the steps below.
Step 1: Locate the connector. The locations of the RS-232 connectors are shown in
Chapter 3.
Step 2: Insert the cable connector. Insert the connector into the serial port header.
See Figure 4-16. A key on the front of the cable connector ensures the
connector can only be installed in one direction.