IEI Integration TANK-600-D2550_N2600 - Manual (Page 28)

TANK-600 Em b e d d e d S ys te m
P a g e 17
Figure 3-6: Mounting Bracket Retention Screws
S te p 3: Secure the brackets to the system by inserting two retention screws into each
bracket (Figure 3-6).
S te p 4: Drill holes in the intended installation surface.
S te p 5: Align the mounting holes in the sides of the mounting brackets with the predrilled
holes in the mounting surface.
S te p 6: Insert four retention screws, two in each bracket, to secure the system to the
wall.
3.4 AT/ATX Mo d e S e le c tio n
AT or ATX power mode can be used on the TANK-600. The selection is made through an
AT/ATX switch located on the bottom panel. To select AT mode or ATX mode, follow the
steps below.
S te p 1: Locate the AT/ATX switch on the bottom panel (Figure 3-7).