IEI Integration TANK-800-D525 v1.14 - Manual (Page 110)

TANK-800 Embedded System
Page 98
Step 2: Install Linux operating system . Make sure to install GRUB (v0.97 or earlier)
MBR type and Ext3 partition type. Leave enough space on the hard drive to
create the recover partition later.
NOTE:
If the Linux OS is not installed with GRUB (v0.97 or earlier) and Ext3,
the Symantec Ghost may not function properly.
While installing Linux OS, please create two partitions:
ƒ Partition 1: /
ƒ Partition 2: SWAP
NOTE:
Please reserve enough space for partition 3 for saving recovery
images.
Figure A-29: Partitions for Linux
Step 3: Create a recovery partition . Insert the recovery CD into the optical disk drive.
Follow Step 1 ~ Step 3 described in Section
75
A.2.2 . Then type the following
commands (marked in red) to create a partition for recovery images.
system32> diskpart
DISKPART> list vol
DISKPART> sel disk 0