IEI Integration TANK-800-D525 v1.14 - Manual (Page 52)

TANK-800 Embedded System
Page 40
3.8 Powering On/Off the System
WARNING:
Make sure a power supply with the correct input voltage is being fed into
the system. Incorrect voltages applied to the system may cause damage to
the internal electronic components and may also cause injury to the user.
ƒ Power on the system: press the power button for 3 seconds
ƒ Power off the system: press the power button for 6 seconds
Figure 3-31: Power Button
3.9 Redundant Power
The TANK-800 is a system that supports redundant power. The redundant power input
increases the reliability of the system and prevents data loss and system corruption from
sudden power failure. The system can instantly and uninterruptedly switch to the second
power input when the main power is unavailable or in low voltage capacity.
There are two power connectors on the rear panel. Power 1 connector is a 3-pin terminal
block that supports ACC On signal. Power 2 connector is a DIN connector that can directly
connect to a power adapter. The supported power input voltages are: