IEI Integration PPC-WIDS-51xxA-G41 - Manual (Page 56)

PPC-51xxA-G41/WIDS-51xA-G41 Panel PC
Page 44
Step 2: Insert the CompactFlash® card into the slot.
Figure 4-10: CompactFlash® Slot
Step 3: Fasten the CompactFlash® cover plate. Step 0:
Figure 4-11: CompactFlash® Cover Plate
4.6.3 CD Drive Installation
To install a CD drive, please follow the steps below.
Step 1: Remove the back cover (Section 4.4).
Step 2: Attach the CD drive adapter to the CD-ROM if it is an IDE drive (if it is a SATA
drive, proceed to Step 5:). Attach a CD drive adapter to a CD drive by aligning
the two retention screw holes in the CD drive adapter with the retention screw
holes on the rear side of the CD drive.
Step 3: Place two spacers between the CD drive and CD drive adapter.