IEI Integration PPC-WIDS-51xxA-G41 - Manual (Page 65)

PPC-51xxA-G41/WIDS-51xA-G41 Panel PC
Page 53
4.9 AT/ATX Mode Selection
AT and ATX power modes can both be used on the PPC-51xxA-G41/WIDS-51xA-G41 flat
panel PC. The selection is made through an AT/ATX switch on the I/O interface panel.
The switch is shown below.
Figure 4-24: AT/ATX Power Switch Selection
4.10 Activating the Front USB Connectors (WIDS Series Only)
A USB switch on the I/O panel of the WIDS-51xA-G41 activates the two USB connectors
on the front panel. To access the USB connectors and activate the connectors, please do
the following:
Step 1: Open the cover. The USB connectors are secured to the front panel of the
WIDS-51xA-G41 with two retention screws. Remove these screws.