IEI Integration AFL-W19A_W19B_17D_W15A-N270 v1.06 - Manual (Page 30)

AFL-W19A/W19B/17D/W15A-N270 Panel PC
Page 18
Figure 2–7: CompactFlash® Install
Step 3: Replace the cover and screws. S te p 0 :
2.5 Jumper Settings
NOTE:
A jumper is a metal bridge used to
close an electrical circuit. It consists of
two or three metal pins and a small
metal clip (often protected by a plastic
cover) that slides over the pins to
connect them. To CLOSE/SHORT a
jumper means connecting the pins of
the jumper with the plastic clip and to OPEN a jumper means removing
the plastic clip from a jumper.
The following jumpers can be found on the motherboard installed in the
AFL-W19A/W19B/17D/W15A-N270. Before the AFL-W19A/W19B/17D/W15A-N270 is
installed, the jumpers must be set in accordance with the desired configuration. The
jumpers on the AFL-W19A/W19B/17D/W15A-N270 motherboard are listed in Table 2-2.