IEI Integration AFL-W19A_W19B_17D_W15A-N270 v1.06 - Manual (Page 50)

AFL-W19A/W19B/17D/W15A-N270 Panel PC
Page 38
large enough for the rear panel of the flat panel PC to fit through. Recommended
cutout size shown below.
Figure 2-27: AFL-W15A-N270 Cutout
Step 3: Slide the flat panel PC through the hole until the aluminum frame is flush against
the panel.
Step 4: Insert the panel mounting clamps into the pre-formed holes along the edges of
the chassis, behind the aluminum frame.
Step 5: Tighten the screws that pass through the panel mounting clamps until the plastic
caps at the front of all the screws are firmly secured to the panel. S te p 0 :