IEI Integration AFL-08AH-N270 - Manual (Page 82)

AFL-08AH-N270-CR Panel PC
Page 68
Serial Port Number [COM1]
Use the Serial Port Number option allows to select the serial port used for remote
access.
COM1 D EFAULT
System is remotely accessed through COM1
NOTE : Make sure the selected COM port is enabled through the Super I/O configuration
menu.
Base Address, IRQ [3F8h,4]
The Base Address, IRQ option cannot be configured and only shows the interrupt
address of the serial port listed above.
Serial Port Mode [115200 8,n,1]
Use the Serial Port Mode option to select baud rate through which the console redirection
is made. The following configuration options are available
115200 8,n,1 D EFAULT
57600 8,n,1
38400 8,n,1
19200 8,n,1
09600 8,n,1
NOTE:
Identical baud rate setting musts be set on the host (a management
computer running a terminal software) and the slave
Redirection After BIOS POST [Always]
Use the Redirection After BIOS POST option to specify when console redirection should
occur.
Disabled The console is not redirected after POST
Boot Loader Redirection is active during POST and during Boot