IEI Integration AFL2-10A-N28 - Manual (Page 126)

AFL2-10A-N28 Panel PC
Page 109
Figure 6-4: DDR SO-DIMM Module Installation
Step 11: Replace the internal cover and secure it to the chassis using the previously
removed retention screws.
Step 12: Replace the back cover and secure it using the previously removed retention
screws. Step 0:
6.5.2 WLAN Card Replacement
The AFL2-10A-N28 has one WLAN card slot. To replace the WLAN card, follow the
instructions below.
Step 1: Follow all anti-static procedures. See Section 6.2.
Step 2: Turn off the power. See Section 6.3.
Step 3: Remove the back cover. See Section 6.4.1 above.
Step 4: Remove the internal back cover. See Section 6.4.2 above.
Step 5: Locate the WLAN card.
Step 6: Disconnect the main and auxiliary antennas on the WLAN module and push the
two spring clips in to release the WLAN card (Figure 6-5).