IEI Integration AFL2-10A-N28 - Manual (Page 61)

AFL2-10A-N28 Panel PC
Page 44
3.12.5 USB Device Connection
NOTE:
User must install the USB 3.0 driver before connecting a USB device to
the system or else the system may not recognize the connected
device.
There are two USB 2.0 connectors and two USB 3.0 connectors on the AFL2-10A-N28. To
connect a USB device, please follow the instructions below.
Step 1: Locate the USB connectors. The locations of the USB connectors are shown
in Chapter 1.
Step 2: Align the connectors. Align the USB device connector with one of the
connectors on the AFL2-10A-N28. See Figure 3-32.
Figure 3-32: USB Device Connection
Step 3: Insert the device connector. Once aligned, gently insert the USB device
connector into the onboard connector. Step 0: