IEI Integration AFL2-10A-N28 - Manual (Page 57)

AFL2-10A-N28 Panel PC
Page 40
Step 1: Locate the DisplayPort connector. The location is shown in Chapter 3.
Step 2: Align the connector. Align the DisplayPort connector with the DisplayPort port.
Make sure the orientation of the connector is correct.
Figure 3-27: DisplayPort Connection
Step 3: Insert the DisplayPort connector. Gently insert the DisplayPort connector. The
connector should engage with a gentle push. If the connector does not insert
easily, check again that the connector is aligned correctly, and that the connector
is being inserted with the right way up.
3.12.3 LAN Connection
There is one external RJ-45 LAN connectors The RJ-45 connector enables connection to
an external network. To connect a LAN cable with an RJ-45 connector, please follow the
instructions below.
Step 1: Locate the RJ-45 connector. The location of the LAN connector is shown in
Chapter 1.
Step 2: Align the connectors. Align the RJ-45 connector on the LAN cable with the
RJ-45 connectors on the AFL2-10A-N28. See Figure 3-28.