IEI Integration AFL2-10A-N28 - Manual (Page 53)

AFL2-10A-N28 Panel PC
Page 36
3.11.5 Stand Mounting
To mount the AFL2-10A-N28 using the stand mounting kit, please follow the steps below.
Step 1: Locate the screw holes on the rear of the AFL2-10A-N28. This is where the
bracket will be attached.
Step 2: Align the bracket with the screw holes.
Step 3: To secure the bracket to the AFL2-10A-N28 insert the retention screws into the
screw holes and tighten them. S te p 0 :
Figure 3-22: Stand Mounting (Stand-A/Bxx)
3.11.6 V-Stand Mounting
To mount the AFL2-10A-N28 using the V-Stand mounting kit, please follow the steps
below.
Step 1: Carefully mark the locations of the four V-Stand screw holes on the mounting
area. Drill four pilot holes at the marked locations for the V-Stand retention
screws.