IEI Integration AFL2-10A-N28 - Manual (Page 59)

AFL2-10A-N28 Panel PC
Page 42
Figure 3-29: DB-9 Serial Port Connector
Step 3: Secure the connector. Secure the serial device connector to the external
interface by tightening the two retention screws on either side of the connector.
3.12.4.2 RJ-45 Serial Port Connection
Follow the steps below to connect a serial device to the RJ-45 serial port connector of the
AFL2-10A-N28 panel PC.
Step 1: Locate the RJ-45 serial port. The location of the RJ-45 serial port is shown in
Chapter 1.
Step 2: Connect the RJ-45 to COM port cable to the panel PC. Insert the RJ-45
connector end of cable into the RJ-45 serial port. See Figure 3-30.
Step 3: Connect the serial device. Connect a serial device to the DB-9 connector end
of the cable. See Figure 3-30.