IEI Integration IBS-19A - Manual (Page 44)

IBS-19A Series Medical Panel PC
Page 44
Step 2: Insert the serial connector . Insert the DB-9 connector of a serial device into
the DB-9 connector on the bottom panel. See Figure 3-15.
Figure 3-15: Serial Device Connector
Step 3: Secure the connector . Secure the serial device connector to the external
interface by tightening the two retention screws on either side of the connector.
3.5.9 USB Connectors
The USB ports are for attaching USB peripheral devices to the system. The pinouts of the
USB port is shown below.
Pin Description Pin Description
1 VCC 5 VCC
2 DATA- 6 DATA-
3 DATA+ 7 DATA+
4 GROUND 8 GROUND
Table 3-7: USB Port Pinouts
To install a USB device, follow the steps below.