2 stand mounting, 3 wall mounting, Figure 3-20: stand mounting – IEI Integration IBS-19A User Manual
Page 49
IBS-19A Series Medical Panel PC
Page 49
3.7.2 Stand Mounting
To mount the IBS-19A Series using the stand mounting kit, please follow the steps below.
Step 1:
Locate the screw holes on the rear of the IBS-19A Series. This is where the
bracket will be attached.
Step 2:
Align the bracket with the screw holes.
Step 3:
To secure the bracket to the IBS-19A Series insert the retention screws into the
screw holes and tighten them.
S
te
p
3
:
Figure 3-20: Stand Mounting
3.7.3 Wall Mounting
To mount the flat panel PC onto the wall, please follow the steps below.
Step 4:
Select the location on the wall for the wall-mounting bracket.
Step 5:
Carefully mark the locations of the four screw holes in the bracket on the wall.
Step 6:
Drill four pilot holes at the marked locations on the wall for the bracket retention
screws.