1 arm mounting – IEI Integration IBS-19A User Manual
Page 47
IBS-19A Series Medical Panel PC
Page 47
3.7.1 Arm Mounting
The IBS-19A Series is VESA (Video Electronics Standards Association) compliant and
can be mounted on an arm with a 100 mm interface pad. To mount the IBS-19A Series on
an arm, please follow the steps below.
Step 1:
The arm is a separately purchased item. Please correctly mount the arm onto
the surface it uses as a base. To do this, refer to the installation documentation
that came with the mounting arm.
NOTE:
When purchasing the arm please ensure that it is VESA compliant and
that the arm has a 100 mm interface pad. If the mounting arm is not
VESA compliant it cannot be used to support the IBS-19A Series.
Step 2:
Once the mounting arm has been firmly attached to its surface, lift the IBS-19A
Series onto the interface pad of the mounting arm.
Step 3:
Align the retention screw holes on the mounting arm interface with those in the
IBS-19A Series. The IBS-19A Series arm mount retention screw holes are