IEI Integration IBS-19A - Manual (Page 45)

IBS-19A Series Medical Panel PC
Page 45
Step 1: Located the USB connectors . The locations of the USB connectors are shown
in Section 1.4.4.
Step 2: Align the connectors. Align the USB device connector with one of the
connectors on the bottom panel. See Figure 3-16.
Figure 3-16: USB Device Connection
Step 3: Insert the device connector. Once aligned, gently insert the USB device
connector into the onboard connector.
3.6 AT/ATX Mode Selection
AT and ATX power modes can both be used on the IBS-19A Series. The selection is
made through an AT/ATX switch on bottom panel (Figure 3-17). To select AT mode or
ATX mode, follow the steps below.
Step 1: Locate the AT/ATX switch on the bottom panel (Figure 3-17).