IEI Integration SRM_121_150 v2.02 - Manual (Page 61)

SRM Series/SRM-KIT Series Monitor
Page 51
5.5.4 Monitor Stand Installation
The SRM series industrial monitor has Video Electronics Standards Association (VESA)
standard mounting holes tapped into the rear panel. The standard holes are M4 set at
100m x 100mm apart (Figure 5-14).
Figure 5-14: VESA Mounting Holes
The monitor stand mounting plate has a matching VESA hole pattern. To mount the SRM
series industrial monitor onto a stand, please follow the steps below.
Step 1: Line up the threaded holes on the monitor rear panel with the screw holes on the
monitor stand mounting plate.