IEI Integration EP-308A v1.12 - Manual (Page 48)

EP-308A POS
Page 38
Î
UDMA1
Ultra DMA mode 1 selected with a maximum data transfer
rate of 25 MB/s
Î
UDMA2 Ultra DMA mode 2 selected with a maximum data transfer
rate of 33.3 MB/s
Î
UDMA3 Ultra DMA mode 3 selected with a maximum data transfer
rate of 44 MB/s (To use this mode, it is required that an
80-conductor ATA cable is used.)
Î
UDMA4 Ultra DMA mode 4 selected with a maximum data transfer
rate of 66.6 MB/s (To use this mode, it is required that an
80-conductor ATA cable is used.)
Î
UDMA5
Ultra DMA mode 5 selected with a maximum data transfer
rate of 99.9 MB/s (To use this mode, it is required that an
80-conductor ATA cable is used.)
ƒ S.M.A.R.T [Auto]
Use the S.M.A.R.T option to auto-detect, disable or enable Self-Monitoring Analysis and
Reporting Technology (SMART) on the drive on the specified channel. S.M.A.R.T predicts
impending drive failures. The S.M.A.R.T BIOS option enables or disables this function.
Î
Auto D EFAULT
BIOS auto detects HDD SMART support.
Î
Disabled Prevents BIOS from using the HDD SMART feature.
Î
Enabled
Allows BIOS to use the HDD SMART feature
ƒ 32Bit Data Transfer [Enabled]
Use the 32Bit Data Transfer BIOS option to enables or disable 32-bit data transfers.
Î
Disabled Prevents the BIOS from using 32-bit data transfers.
Î
Enabled D EFAULT
Allows BIOS to use 32-bit data transfers on supported
hard disk drives.