IEI Integration EP-308A v1.12 - Manual (Page 59)

EP-308A POS
Page 49
ƒ 115200 8,n,1 D
EFAULT
ƒ 57600 8,n,1
ƒ 38400 8,n,1
ƒ 19200 8,n,1
ƒ 09600 8,n,1
NOTE:
Identical baud rate setting musts be set on the host (a management
computer running a terminal software) and the slave
ƒ Flow Control [None]
Use the Flow Control option to report the flow control method for the console redirection
application.
Î
None D EFAULT
No control flow,
Î
Hardware Hardware is set as the console redirection
Î
Software Software is set as the console redirection
ƒ Redirection After BIOS POST [Always]
Use the Redirection After BIOS POST option to specify when console redirection should
occur.
Î
Disabled The console is not redirected after POST
Î
Boot Loader Redirection is active during POST and during Boot
Loader
Î
Always D EFAULT
Redirection is always active (Some OSes may not
work if set to Always)
ƒ Terminal Type [ANSI]
Use the Terminal Type BIOS option to specify the remote terminal type.