Pumptec ELECTRIC SPRAYER 12V - Manual (Page 7)

7 Version 110112
Pumptec Operating Instructions and Parts Manual 12V ELECTRIC SPRAYER
RECOMMEnDED MOUnTIng OF CABlES AT SWITCH
1. Connect cable (A) from positive post of battery #1 to switch
terminal #1.
2. Connect cable (B) from positive post of battery #2 to switch
terminal #2.
3. Connect cable (C) from starter solenoid and cable (D) from
accessory (load) to Feeder terminal on switch.
4. See “Wiring” for cable and terminal requirements.
CABlE lUg InSTAllATIOn
Remove top nut and washer only. Removing bottom nut will
damage the switch. Tighten nut to 150 in-lbs.
coxrEELS haNd craNk hoSE aNd cabLE rEELS
IMPortANt: Read these instructions carefully before
attempting to install, operate, or maintain this product.
Only qualified personnel should undertake the installation
and commissioning of this product. Failure to comply with
instructions could result in personal injury and/or property
damage.
PERSOnAl SAFETY
• Ensure reel has been properly installed before connecting
supply line.
• Before connecting to reel, be certain supply line does not
exceed reated pressure of the hose reel or amperage rating
on cable reel.
• Thoroughly review the “Hose Installation” Instructions to
properly install hose.
• Perform “Operational Check”per instructions to ensure reel
is operating properly.
• If a leak should occur after applying pressure to the reel,
immediately discontinue supply line pressure.
warNiNG!
Prevent static sparking. When working
around flammables, ensure that the hose reel, hose and
equipment are properly grounded. Use only grounded hose(s).
Check continuity of ground circuit with ohmmeter.
MOUnT REEl/FASTEn CRAnK-HAnDlE
1. To mount reel to a solid structure you will need 7/16”
M12 bolts, washers and nuts. Masonry bolts may b used
depending on mounting application. Mounting hardware is
nOT provided. Mounting patterns will vary depending on
model.
Note: If you choose to permanently mount series CM, you will
need four 1/4” screws or nails.
2. Fit mounting hardware to ceiling/wall/floor so reel can be
fastened into position. Fit reel and tighten all hardware
securely.
3. Reels are supplied with plastic crank handle uninstalled.
Remoe handle and hardware from plastic bag and install
onto crank arm. Models 1275 and 600-900 will include
detachable crank for bevel gear design.
4. The series DM portable reels will include a U-shaped
handle. Position handle over swaged posts and fasten using
hardware povided.
InSTAllATIOn OF InlET HOSE
1. Apply thread sealant to inlet house and connect to teh swivel
joint on reel.
cAutIoN!
It is important to use a “flexible” inlet hose.
Do not use solid piping or restrain inlet hose as to cause any
side force on swivel joint. The warranty is void if not properly
installed.
2. Flush some product through the system before connecting
inlet hose to the source. Connect end to supply source.
InSTAllATIOn OF OUTlET HOSE
Note:
Before proceeding, ensure that you are installing the
proper size, length and type of hose that the reel is rated for.
Consult factory if unsure of rating.
1. Securely install hose reel prior to installing outlet hose. Apply
thread sealant to male hose fitting and insert into the drum
opening.