Pumptec ELECTRIC SPRAYER 12V - Manual (Page 9)

9 Version 110112
Pumptec Operating Instructions and Parts Manual 12V ELECTRIC SPRAYER
troUbLEShootiNG chart
SyMPtoM PoSSibLE caUSE(S) corrEctiVE actioN
Hose/Cable wil not fully fit on
to drum of reel
1. Hose/Cable is longer than specified.
2. Outside diameter o hose is larger than
specifications
3. Hosecable was not hand guided onto reel and
wound up unevenly on drum.
1. Cut down hose/cable to meet reels specified
capacity.
2. Replace hose with a hose that meets
the specified maximum outside diameter
requirements.
3. Hand guide hose/cable on to drum as it is
wound on to the reel.
Reel keeps truning when
operator stops pulling out
hose/cable.
1. Tension drag brake is too loose causing hose/
cable backlash.
1. Adjust tension drag brake by turning fastener
clockwise.
no electrical current at output
end of cable. (1125WC Series
only)
1. Cable is severed.
2. Slip ring brushes are worn
1. Replace cable.
2. Replace slip ring brushes.
note: Ensure current does not exceed rated
amperage.
Drum of reel is crushed or
damaged
1. Hose was not charged when initially installed
on to reel.
1. REplace damaged drum. Contact factory
install hose per instructions
Fluid path (plumbing and/or
swivel) is leaking or damaged
1. Maximum pressure rating for reel has been
exceeded.
2. Application is not compatible with plumbing
and/or swivel seal materials
1. Replace or repair damaged components.
Consult factory. Check maximum pressure
rating or reel
2. Contact factory to determine chemical
compatibility or environmental issues (i.e.
temperatur rating)
Fluid leaks from swivel 1. Swivel seals are damaged or worn 1. Replace swivel seals. See “Swivel seal
replacement”. Caution: Be sure leak is not at
hose fitting.