Ramsey Winch DCS-200 SPEED REDUCER - EZ ANCHOR User Manual
Page 10
10
7. Remove seal (item #41) from back of
gear housing (item #10). Check bush-
ing (item #19) for signs of wear. Press
bushing (item #19) from gear housing
and replace if necessary. Press new
bushing and seal back into place.
8. Check cover bushing (item #18) for
signs of wear. Replace if necessary
by removing old bushing and pressing
new bushing into place.
9. Check gears of spur gear shaft assembly
for signs of wear, replace if necessary.
Press old gears from shaft (item #13). Tap
key (item #12) into keyway of shaft (item
#13). Press shaft through gears (item #7)
so that gears are centered on shaft and key.
10. Apply grease to end of shaft op-
posite gear. Apply grease to bush-
ing in gear housing (item #10).
Place greased end of shaft through
thrust washer (item #45) and bush-
ing in gear housing (item #10).
Place gasket (item #30) onto gear
housing cover (item #4). Apply
grease to gear end of shaft and
bushing in cover. Place thrust
washer (item #46) on gear end of
shaft. Place cover onto shaft and
secure to housing with fi ve (item
#21) cap screws at the fi ve lower
most
holes.
13
12
7
7