Ramsey Winch DCS-200 SPEED REDUCER - EZ ANCHOR - Manual (Page 8)

8
3. Remove key (item #11) and snap
ring (item #43) from worm shaft.
Remove motor (item #33) from
spur gear housing (item #9) by
removing (3) nuts and lock wash-
ers (items #25 and #27). Un-
screw (4) cap screws (item #23) to
remove spur gear box (item #9)
and gasket (item #28) from gear
housing. Replace lip seals (items
#40 & #42) by pressing old seals
from spur gear housing and press-
ing new seals into place.
2. Drain oil spur gear housing by removing
(item #35) plug. Remove cover and gasket
(items #5 & #29) from spur gear housing by
unscrewing twelve cap screws (item #20).
Slide gear (item #7) from end of worm shaft
(item#15) with gears attached. Check bear-
ings (item#16) and thrust washers (item#44)
for signs of wear, replace if necessary.
Remove old bearings and press new bear-
ings into place. Remove solenoid assembly
(item #1) by unscrewing cap screws (items
#22 and #24). Disconnect solenoid cables
from motor (item #33). Make note of which
terminals cables are attached to.
1. Drain oil from worm gear housing by
removing (item #35) plug from bottom
of gear housing. Remove relief fi tting
and reducer (items #32 & #34) from
top of gear housing. Remove Speed
Reducer from mounting.
INSTRUCTIONS FOR OVERHAUL OF RAMSEY
DCS-200 SPEED REDUCER