Ramsey Winch DCS-200 SPEED REDUCER - EZ ANCHOR - Manual (Page 11)

11
10. Press bearing (item #17) onto worm.
(item
#15). NOTE: Be sure thick shoulder
of bearings outer race (side with
manufacturer’s name and part number) is
out, away from worm threads. Press
bearing and worm into gear housing. Slip
gasket (item #28) onto bearing cap (item
#3). Use four cap screws (item #21) to
secure cap to gear housing. Torque cap
screws to 7 ft-lbs (9.4 Nm) each.
Attach solenoid assembly (item #1) to
gear housing. Use two (item #24) cap
screws and three (item #22) cap screws
with three fl at washers (item #26).
Tighten cap screws to 7 ft-lbs. (9.4 Nm)
each. Insert plug (item #37) into tapped
hole of cover. Permatex may be applied
to threads to help prevent oil leakage.
TIGHTEN plug securely.
11. Press bearing (item #17) onto worm
and into worm gear housing. NOTE:
Be sure thick shoulder of bearings
outer race (side with manufacturer’s
name and number) is out, away
from worm threads. Place gasket (item
#28) onto spur gear housing (item #9).
Secure spur gear housing to worm gear
housing using four cap screws (item
#23). Torque cap screws to 7 ft-lbs (9.4
Nm) each.
Mount motor (item #33) to spur gear
housing (item #9) using three lock
washers and nuts (items #25 and #27).
Attach solenoid cables to motor
terminals. Tighten all nuts securely.