AT&T E5654B - Manual (Page 10)

8
Getting Started
Wall mounting
The base can be installed on any standard wall phone outlet as shown below. Choose a
location away from electronic equipment, such as personal computers, computer rout-
ers, television sets or microwave ovens. Avoid excessive heat, cold, dust or moisture.
Plug power adapter
into electrical outlet.
Plug telephone line
cord into telephone
cord wall jack.
1) Connect telephone line cord and power
adapter to telephone jacks and wall
jacks, as shown on page 6.
2) Install wall mount bracket onto the set.
(a) First put the two front wall mount
bracket tabs into the front notches on
the bottom of the telephone base.
(b) Squeeze the rear tabs of the wall
mount bracket as you insert them into
the rear notches on the bottom of the
telephone base.
NOTE: To disassemble the wall
mount bracket, squeeze the rear tabs while
lifting up the wall mount bracket back and
away from the telephone base.
3) Position the wall-mount bracket
over the wall-outlet mounting pegs,
and press and slide the wall-mount
bracket down firmly so it is held
securely on the outlet mounting
pegs.
b
a a
b