AT&T E5654B - Manual (Page 52)

0
Appendix
The CHARGING
light is off
• Clean the charging contacts on the cordless handset(s) and telephone
base each month using a pencil eraser or a dry non-abrasive fabric.
• Make sure the power adapter and telephone line cords are plugged in
correctly and securely.
• Unplug the power adapter. Wait for 1 seconds before plugging it back
in. Allow up to one minute for the cordless handset and telephone base
to synchronize.
• The telephone might be malfunctioning. Please refer to the Limited
Warranty section of this user's manual for further instruction.
The CHARGING
light on the
telephone base
is flashing
• This is a signal that the battery is very low, completely depleted, or
when there is no electrical contact between the battery and the tele-
phone base.
• Ensure the connector of the battery is securely plugged into the hand-
set and place the handset in the telephone base for charging.
Troubleshooting
Problem Suggestion
There is no dial
tone
• First, try all the above suggestions.
• Move the cordless handset closer to the telephone base. It might be
out of range.
• The telephone line cord might be malfunctioning. Try installing a new
telephone line cord.
• Disconnect the telephone base from the telephone jack and connect
a different telephone. If there is no dial tone on this telephone either,
the problem is in the wiring or the local service. Contact the local tele-
phone company.