AT&T E5654B - Manual (Page 41)

3
Answering System Operation
1.
Remote access
A two digit security code is required to access your
answering system from any touch-tone phone. This code
is
19 by default; see page 35 to change it.
Dial your telephone number from
any touch-tone phone.
2. When system answers, enter
two digit remote access code ( 19
unless you have changed it).
3. Enter remote commands
(see list at right).
4. Hang up to end call and save all
undeleted messages.
Play all messages
1
Play new messages
2
Delete the message
3
33
Repeat or go back
4
Stop
5
Skip to next message
6
Review announcement
#7
Record announcement
*7
to begin recording
5
to stop recording
Record memo
8
to begin recording
5
to stop recording
Review remote access code
#9
Change remote access code
*9
Press to hear all messages.
Press to hear new messages.
Press during playback to delete current
message. Press
3 twice to delete all old
message.
Press during the caller’s message to
repeat the message. Press during the
beginning of the day and time announce-
ment to go back to the previous caller’s
message.
Press to stop any operation (stop play-
back, stop recording).
Press to skip current message and
advance to next message.
Press to review current outgoing
announcement.
Press * 7, wait for beep, then begin
speaking. Press 5 to stop recording and
hear playback of new announcement.
Press 8, wait for beep, then begin speak-
ing. Press 5 to stop recording.
Press # 9 to review remote access code.
Press * 9 to change remote access code,
then enter desired remote access code
from 10-99.
NOTE: If you pause for
more than 10 seconds during
remote access, you will hear a
help menu listing all features &
commands. If you issue no
command for another 20 seconds,
the call will end automatically.