AT&T E5654B - Manual (Page 9)


Getting Started
Battery installation & charging
After battery installation, place each handset in the base or charger and allow to charge
for at least 16 hours before use. You can keep the battery charged by returning the hand-
sets to the base or charger after each use. When the battery is fully depleted, a recharge
takes about 12 hours. The average talk time on a fully charged battery is about eight
hours depending on environmental conditions and the standby time is approximately
fours days.
Plug the battery
pack connector
into handset.
Place the battery
pack and wires in
the compartment.
Place handset in base or charger
to charge for at least 16 hours
before first use.
Plug power adapter
into an electrical outlet
not controlled by a wall
switch.
Low battery indicator
Return handset to base
or charger to recharge
when this symbol flashes.
(Handset will beep when
battery is low.)
Caution: Use only supplied recharge-
able battery or AT&T replacement
battery model 27910 (SKU 00102. Part
number 89-0099-00-00).
LOW BATTERY
Press tab to open
battery compartment. Replace compartment cover.
NOTE: Use only the power cord supplied with this product. If you need a replacement, call 1-800-222-3111. Be
sure to use an electrical outlet not controlled by a wall switch.