Watlow 12LS Controller User Manual
Watlow Sensors
Advertising
Table of contents
Document Outline
- TITLE
- TABLE OF CONTENTS
- 1.0 INTRODUCTION
- 2.0 SPECIFICATIONS
- 3.0 INSTALLATION
- 3.1 PHYSICAL CONSIDERATIONS
- 3.2 TERMINAL BLOCK AND CONNECTOR LAYOUT
- 3.3 ANALOG INPUTS
- 3.3.1COMMON MODE VOLTAGE
- 3.3.2NORMAL MODE VOLTAGE
- 3.3.3GROUNDING
- 3.3.4 SOURCE IMPEDANCE
- 3.3.5 INPUT SCALING
- 3.3.6 VOLTAGE INPUTS
- 3.3.7MILLIAMP INPUTS
- 3.3.8THERMOCOUPLE INPUTS
- 3.3.9RTD INPUTS
- 3.3.10 INFRARED NON-CONTACT TEMPERATURE SENSORS
- 3.3.11 SCALING AND CALIBRATION
- 3.3.12 DIAGRAMS OF TYPICAL INPUTS
- 3.4 CONTROL OUTPUTS
- 3.5 COMPUTER SERIAL COMMUNICATIONS
- 4.0 FRONT PANEL OPERATION AND DISPLAYS
- 4.1 FRONT PANEL KEYS
- 4.2 DISPLAYS
- 4.3 GENERAL PROGRAMMING AND EDITING
- 4.4 OPERATIONAL MENUS
- 4.5 SETUP MENUS
- 4.6 RAMP AND SOAK OPTION
- 4.7 SETUP RAMP/SOAK PROFILE
- 4.7.1 SELECT A PROFILE FOR EDITING
- 4.7.2 COPY ANOTHER PROFILE
- 4.7.3 EDIT TOLERANCE ALARM TIME
- 4.7.4 EDIT READY SETPOINT
- 4.7.5 EDIT READY EVENT STATES
- 4.7.6 EDIT EXTERNAL RESET
- 4.7.7 EDIT SEGMENT NUMBER
- 4.7.8 EDIT SEGMENT TIME
- 4.7.9 EDIT SEGMENT SETPOINT
- 4.7.10 EDIT SEGMENT EVENTS
- 4.7.11 EDIT EVENT OUTPUT NUMBER
- 4.7.12 EDIT EVENT OUTPUT STATE
- 4.7.13 EDIT SEGMENT TRIGGERS
- 5.0 PID CONTROL
- 6.0 SOFTWARE
- 7.0 TROUBLE SHOOTING INFORMATION
- 8.0 SOFTWARE COMMAND STRUCTURE
- 9.0 GLOSSARY OF TERMS