Watlow EZ-ZONE RMC - Manual (Page 127)

Watlow EZ-ZONE ® RMC Module • 124 • Chapter 4 Setup Page
RMC Module • Setup Page
Dis-
play
Parameter Name
Description
Range Default
Modbus
Relative
Address
CIP
Class
Instance
Attribute
hex (dec)
Profibus
Index
Parameter
ID
Data
Type
& Read/
Write
[`PAr]
[ PAr] Communications
Parity
Set the parity of this
controller to match the
parity of the serial net-
work.
Note:
This applies if 13 th
digit in part number is
equal to one.
[none] None (61)
[EuEn] Even (191)
[`odd] Odd (192)
None 2826 0x96 (150)
1
4
- - - - 17003 uint
RWE
[`nU;S]
[ nV.S] Communications
Non-volatile Save
If set to Yes all values
written to the control
will be saved in EE-
PROM.
Note:
This applies if 13 th
digit in part number is
equal to one.
[`yes] Yes (106)
[``no] No (59)
Yes 2834 0x96 (150)
1 to 2
8
198 17051 uint
RWE
[M;hL]
[M.hL] Communications
Modbus Word Order
Select the word order of
the two 16-bit words in
the floating-point values.
Note:
This applies if 13 th
digit in part number is
equal to one.
[hiLo] Word High Low (1330)
[Lohi] Word Low High (1331)
Low High 2828 0x96 (150)
1
5
- - - - 17043 uint
RWE
[`C_F]
[ C_F] Communications
Display Units
Select which scale to use
for temperature passed
when using Modbus
Note:
This applies if 13 th
digit in part number is
equal to one.
[```F] °F (30)
[```C] °C (15)
°F 2830 0x96 (150)
1
6
199 17050 uint
RWE
No Dis-
play
Communications
Protocol
Select the communica-
tions protocol.
Standard Bus (1286)
Modbus RTU Word (1057) 1 2832 - - - - - - - - 17009 uint
RWE
Note:
Some values will be rounded off to fit in the four-character display .
Full values can be read with other interfaces .
Note:
If there is only one instance of a menu, no submenus will appear .
** These parameters/prompts are available in these menus with firmware revisions 6 .0 and
above .
R: Read
W: Write
E: EEPROM
S: User Set