Yokogawa RotaMASS 3-Series - Manual (Page 5)

IM 01R04B08-00E-E 1st edition February 15, 2012 -00 All Rights Reserved. Copyright © 2012, Rota Yokogawa
<1. INTRODUCTION>
1-1
This instrument has been adjusted at the factory
before shipment.
To ensure correct use of the instrument, please
read this manual thoroughly and fully understand
how to operate the instrument before operating it.
NOTE
This manual describes the hardware and soft-
ware configurations of the Rotamass Coriolis
Massflowmeter.
Regarding This User's Manual
• This manual should be provided to the end user.
• Before use, read this manual thoroughly to com-
prehend its contents.
• The contents of this manual may be changed
without prior notice.
• All rights are reserved. No part of this manual
may be reproduced in any form without Yokoga-
wa's written permission.
• Yokogawa makes no warranty of any kind with
regard to this material, including, but not limited
to, implied warranties of merchantability and
suitability for a particular purpose.
• All reasonable effort has been made to ensure
the accuracy of the contents of this manual.
However, if any errors or omissions are found,
please inform Yokogawa.
• Yokogawa assumes no responsibilities for this
product except as stated in the warranty.
• Please note that this user's manual may not be
revised for any specification changes, construc-
tion changes or operating part changes that are
not considered to affect function or performance.
• If the customer or any third party is harmed by
the use of this product, Yokogawa assumes no
responsibility for any such harm owing to any
defects in the product which were not predict-
able, or for any indirect damages.
Safety and Modification Precautions
• The following general safety precautions must
be observed during all phases of operation,
service, and repair of this instrument. Failure to
comply with these precautions or with specific
WARNINGS given elsewhere in this manual
violates safety standards of design, manufacture,
and intended use of the instrument. Yokogawa
assumes no liability for the customer's failure
to comply with these requirements. If this instru-
ment is used in a manner not specified in this
manual, the protection provided by this instru-
ment may be impaired.
• The following safety symbol marks are used in
this user's manual and instrument.
WARNING
A WARNING sign denotes a hazard. It calls at-
tention to procedure, practice, condition or the
like, which, if not correctly performed or adhered
to, could result in injury or death of personnel.
CAUTION
A CAUTION sign denotes a hazard. It calls at-
tention to procedure, practice, condition or the
like, which, if not correctly performed or adhered
to, could result in damage to or destruction of
part or all of the product.
IMPORTANT
An IMPORTANT sign denotes that attention is
required to avoid damage to the instrument or
system failure.
NOTE
A NOTE sign denotes information necessary for
essential understanding of operation and fea-
tures.
1. INTRODUCTION