Yokogawa Button Operated DX2000 - Manual (Page 35)

2-22
IM 04L41B01-62EN
2.8 Components Explanation and Creation
Examples
This section shows creation examples for components. Components created with
DAQStudio and components of the custom display execution screen of the DX recorder
differ in the display of measuring data, alarm display, etc. The components creation
examples are a mix of components created with DAQStudio and those of the custom
display execution screen of the DX recorder.
For components other than lines, the upper left apex of the component is the origin for
positioning on the grid, and the lower right apex is positioned at (origin - 1 dot).
For components that enable text label entry, any characters entered exceeding the
maximum allowed number are deleted.
Diagram Components
Line
You can draw a line going in the left/right or up/down direction from an origin. Origin
If the start and end points overlap, 1 dot of space along the X axis is inserted. Start and
end points are positioned on the grid.
Rectangle
Origin
You can draw a rectangle from an origin toward the lower right.
Background color
Circle
Origin
A circle contacting a square
from the inside is drawn.
Background color
A circle is drawn by dragging from a point of origin.
Even when a rectangle is specified,
a circle is drawn, but an ellipse
cannot be drawn.
Components for Channel Assignment
Restrictions on channel assignments
The measured value of the assigned channel is displayed in the DX recorder execution
panel.
With the Math (/M1) and PROFIBUS-DP (/CP1) options, PROFIBUS-DP always uses the
communication input channels in the table below. The channels in the table below cannot
be assigned using DAQStudio.
Channels used with the /M1 and /CP1 option
Type Communication input channels used
DX1000 C01 to C24 (all)
DX2000 C01 to C32
Simple digital
The digital value of the specified channel is displayed.
Digital value
***** is displayed with DAQStudio.
Simple digital display area (Frame: Sunken)