Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 58)

8-6 IM 04L31A01-01E
8.3 Removing the Keyboard
1. Remove the bezel (see section 8.1).
2. Remove the two screws attaching the aluminum sheet to the back of the bezel.
3. Remove the keyboard flat cable rivet.
When removing the rivet, first pull out the pin.
Rivet
Aluminum Sheet
4. Use the tip of a pen to push in the hinge pin on the left side of the Key Case
assembly, then pull the assembly toward you to remove it.
Be careful not to damage the flat cable when removing the assembly.
5. Remove the two front case screws from the back of the key board.
Tightening torque: 0.5—0.6 Nm (5—6 kgf cm)
6. The front case is snapped on to the front cover. Use a tool such as a flathead
screwdriver to pry open the front case and remove it.