Stuart Turner Monsoon Extra S3.0 bar Single - Manual (Page 5)

- 5 -
The pipework feeds to the storage tank should be of adequate size to ensure
replenishment rate of tanks is sufficient to meet needs of pump.
Care should be taken in the design of pipework runs, to minimize the risk of air locks.
To prevent loss of water pressure through pipework use 28 mm suction pipework to the
pump minimising 90° bends.
Isolating valves (not supplied) should be fitted on the suction and delivery pipework to
enable easy isolation and access to the pump.
The 1” inline strainer as supplied should be fitted in the suction line to the pump between
the isolating valve and the pump. This will eliminate the risk of debris or scale entering the
pump.
Pipework Connections (Cold)
The pump must be supplied with a dedicated feed direct from the cold water
storage tank.
Ensure the pipework size from the cold water storage tank to the pump is of adequate
size and a minimum of 28 mm.
The supply must be air free and connections of the feed pipe to the tank should be via a
tank connector, positioned at a slightly lower level (25 mm minimum) than the feed pipe to
the hot water cylinder.
S1.4 bar Single
Fig. 5
TURNER LTD
S3.0 and S3.5 bar Single
Fig. 6
S4.5 bar Single
Fig. 7
Outlet
Outlet
Outlet
Outlet
Fitting
Outlet
Fitting
Outlet
Fitting
Inlet
Inlet
Inlet
Flow Switch
Body
Flow Switch
Body Flow Switch
Body